Door seals & sweeps · Atlanta & Metro Atlanta, GA
Daylight around a closed front or back door or a draft at your ankles means the door weather seal has worn out. We replace it, and the door sweep, so the door closes snug again.
What we do
Most exterior doors seal in three places. When one has failed, we look at the other two on the same visit, since they have aged as long.
The foam or rubber strip set into the frame on the hinge side, latch side and head gets flattened, torn or painted stiff over the years. We pull it and press a new one into the same kerf, or fasten a new one along the stop on a door without one.
A sweep along the bottom of the door closes the gap above the threshold. We fit one sized to your door, screwed on or slid into the door bottom, set low enough to seal without dragging on the floor.
Where the threshold has a replaceable insert or an adjustable cap, we replace or raise it so it meets the sweep. A threshold that is rotted underneath is a bigger repair, and we tell you so.
The same work on the door from the garage into the house, a side door or a back door. The door has to be already hung and swinging; we do not hang new doors.
When the door itself needs work, or the house needs other sealing: Door repair & adjustment · Caulking & sealing services
How we work
Text a photo of the door edge and the bottom of the door to our number, or describe it in the form or on the phone. Many seals are made for a particular door, so a photo lets us bring the right profile. The estimate is free.

We take out the worn strip and the old sweep, clean the groove and the door bottom, and fit the new pieces. If the door is out of line and that is why the seal failed, we say so first; adjusting the hinges or strike is door repair.

With the door shut we check every edge for light and feel for air, then open and close it a few times to make sure the latch still catches without a hard push.

Why homeowners choose us
A seal that is too thick makes the door hard to latch; one that is too thin lets the draft back in. The fit is the whole job.

The quote
It is priced by the visit and the number of doors, by how many of the seals need replacing and whether the parts are stock or have to be matched. You hear the price before we start. Starting at $125 for the visit. Labor only; materials are extra, and the final price is confirmed on site before any work starts.
Good to know
Have a question about your job? Call or text (770) 746-7207 and we'll talk it through with you before you book anything.
Close the door on a sunny day or at night with the porch light on and look at the edges from inside. Light along the frame or under the door, a draft you can feel with a wet hand, or a seal that is cracked, flat or missing in places all point to worn weather stripping.
It depends on the frame. Most steel and fiberglass doors have a slot, called a kerf, in the jamb, and take a foam or rubber seal that presses into it. Older wood doors without a slot take a seal fastened along the stop instead, or a thin bronze or vinyl strip on the jamb. A photo of the door edge, texted to our number, tells us which one to bring.
We can, where the door itself is sound. A seal that is too thick, or set in the wrong groove, pushes the door off the latch. We fit one of the right size, and if the door also needs its hinges or strike adjusted, we quote that as door repair.
We do not replace doors or whole thresholds, and we do not hang new or pre-hung doors. We replace the seals, the sweep and a threshold insert; a threshold rotted or loose underneath is a bigger job than a seal, and we tell you what it needs before anything else.
It stops the draft and the light at that door. How much that changes a bill depends on the house, the doors and the season, so we do not promise a figure.
Where we work
Based at 8735 Dunwoody Pl Ste R, Atlanta, GA 30350, serving the communities below.
Live just outside these towns? Give us a call and tell us where you are, and we'll let you know if we can get to you.
Free estimate
Send the form and we'll call you back during business hours to talk through the job and set up your free estimate.